Bob and Karen Brown's Airplane Building Project


 
Home Page   Getting Started   Shop and Tools
Empennage   Electrical Systems   Trouble Spots
Fuselage   Engine and Firewall   Primer and Paint
Wings   Fiberglass    

Finished Rudder Strobe

 Here you can see the fit of the strobe unit on the lower rudder fairing.  After I match drilled the base of the strobe unit to the fairing, I bought some stainless steel 4-40 x 1 1/4" screws at the hardware store which I set backwards into the fiberglass using flox.  I bought some 4-40 acorn nuts to secure the strobe unit to the screws.  The hole for the strobe was drilled using a Unibit 

Last edited 28-Dec-2005